Sanding – The Traditional Refinishing Method

The sanding process

A full sand-and-refinish happens in stages:

Rough cut (36 or 40 grit) – drum sander removes the old finish and any surface damage.
Medium grit (60 grit) – smooths scratches from the rough cut.
Fine grit (80 or 100 grit) – final smoothing so the floor accepts stain evenly.
Edging – hand-edger reaches areas the drum sander can’t, using the same grit progression.
Corners + tight spots – hand scrapers and detail sanders.
Vacuum + tack – HEPA vacuum, then wipe with tack cloth to remove remaining dust before finish.
Water pop (optional) – lightly dampen the floor to open grain for stain penetration.
Stain (optional) – apply stain with lambswool applicator, wipe off excess, dry 24 hours.
Sealer or first poly coat – dries 4–12 hours.
Screen between coats – 220 grit screen to knock down raised grain.
Additional poly coats (2–3 total) – each dries 4–24 hours depending on formulation.

Total timeline: 4–6 days with water-based poly, 5–7 days with oil-based.

Why sanding still matters

ReCoating solves the “my finish is worn” problem. But if the wood itself is damaged, sanding may be part of the assessment:

Gouges from furniture drag, high heels, or pet nails that expose bare wood
Water damage or cupping from moisture
Stain color that you want to change

Pet stains and UV fade need an in-person assessment because sanding alone may not remove them. Some floors need repair, replacement, or another method before any finish system makes sense.

The wear-layer budget

Every sanding uses up part of your floor’s wear layer (the thickness of wood above the tongue-and-groove joinery). Solid 3/4-inch hardwood has roughly 3/8 of an inch of usable wear layer. Each full sand removes around 1/16 of an inch, meaning you get 4–6 total sandings over the floor’s life.

ReCoating uses zero wear-layer budget. If your floor can qualify for a ReCoat, always ReCoat instead of sanding – you’re preserving future sanding options.

What “dustless sanding” means

Dust-containment sanding uses shrouded sanders connected to HEPA vacuums, plastic sheeting at room entries, and negative-air machines to keep dust out of HVAC. It’s 95–99% better than uncontained sanding. It’s still not truly dust-free, which matters for homes with asthma, allergies, or valuable electronics. For truly zero-dust results, use ReCoating with chemical abrasion instead of any sanding.

Frequently Asked Questions

How many times can a hardwood floor be sanded?

Solid 3/4-inch hardwood can typically be fully sanded 4–6 times over its life before reaching the tongue-and-groove joinery beneath the wear layer. Each sanding removes roughly 1/32 to 1/16 of an inch. Engineered hardwood sandability depends entirely on veneer thickness: 4mm+ veneers can be sanded 2–3 times, 2–3mm veneers once, and sub-2mm veneers not at all.

Do I have to sand to change stain color?

Yes. Stain must penetrate bare wood fibers to color the floor. It will not bond through an existing polyurethane finish – any stain color change requires a full sand-to-bare-wood first.

Is dustless sanding worth the premium?

Yes, if you’re doing a full sand. It captures 95–99% of visible dust and dramatically reduces cleanup time. But it’s still not truly zero-dust; fine airborne particles still settle for days. If dust-sensitivity is your primary concern, ReCoating (which uses chemical abrasion, not sanding) is the right choice when your floor qualifies.